CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions.
To connect your monitor to the computer perform the following
steps/instructions:
Turn off your computer and disconnect the power cable.
Connect
either the white (digital DVI-D) or the blue (analog VGA) display connector
cable to the corresponding video port
on the back of your computer. Do
not use both cables on the same computer. Use both the cables only when they
are connected to two different computers with appropriate video systems.
Connecting the white DVI cable
Connecting the blue VGA cable
NOTE:
The Graphics are used for the
purpose of illustration only. Appearance of the the computer may vary.
After you have
completed connecting the DVI/VGA cable, follow the procedure below to complete
your monitor setup:
Plug the power cables for your computer and monitor into a nearby
outlet.
Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
display an image, see
Solving
Problems.
Use the cable management
slot on the monitor stand to organize the cables.
After attaching all necessary cables to your monitor and computer,
(See Connecting Your Monitor for cable attachment,)
use the cable management slot to neatly organize all cables as shown above.
