Turn off the monitor and unplug it from the electrical
outlet.
2.
Place the monitor upside down on a padded, flat work surface.
Bottom of Monitor
1
Tab slots (6)
3.
Align the tabs on the swivel base with the corresponding
slots on the bottom of the monitor.
NOTE:
The base will align with the monitor slots in only one
position.
4.
Press the swivel base onto the monitor until the tabs are
fully engaged in the slots, and then push the swivel base toward the
front of the monitor until the release latch clicks into the locked
position.
1
Release latch
2
Tabs (4)
3
Tab slots (4)
Removing the Tilt/Swivel Base
1.
Place the monitor upside down on a stable, flat work
surface.
2.
Squeeze and pull up the release latch on the swivel base.
3.
Push the swivel base toward the back of the monitor and
lift up to remove the base.
Cable Connections the Back of the Monitor and Computer
1.
Turn off your computer and unplug its power cable.
2.
Connect the blue connector of signal cable to the blue
video port on the back of your computer.
NOTE: The graphics are for illustration only. System
appearance may vary.
3.
Connect the power cord for your monitor to the AC plug on
the back of the monitor.
4.
Plug the power cords of your computer and monitor into a
nearby outlet.
5.
Turn on your monitor and computer.
If your monitor displays an image, installation is complete. If it does
not display an image, see
Troubleshooting
Your Monitor.
