Back to Contents
Page
Regulatory : Dell™ M770
Color Monitor User's Guide
Electric and
Magnetic Fields • Energy Efficiency • Federal
Communications Commission (FCC) Statement • CE Declaration
of Conformity • EN 55022 Compliance (Czech Republic Only)
• VCCI Class 2 Notice (Japan Only) • MOC Notice
(South Korea Only) • Polish Center for Testing and
Certification Notice •
NOM Information (Mexico Only) • BCIQ Notice (Taiwan Only) • Ergonomics Notice
(Germany Only)
Dell Computer Corporation's
Environmental Program •
Design for Recyclability • Dell's Blue
Angel Disposal Program • Green Away Collection
Points
Electric and Magnetic Fields
 |
Electric
and Magnetic Fields
Energy Efficiency
|
The proper operation of the function requires a computer
with VESA® DPMS power management capabilities. When used with a computer
equipped with VESA DPMS, the monitor is ENERGY STAR® compliant. As an
ENERGY STAR® Partner, Dell Computer Corporation has determined
that this product meets the ENERGY STAR® guidelines for energy efficiency.
|
Federal Communications
Commission (FCC Statement)
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
This device complies with part 15
of FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful
interference.
- This device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. Use only
RF shielded cable that was supplied with the monitor when connecting this monitor
to a computer device.
THIS CLASS B DIGITAL APPARATUS MEETS
ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE-CAUSING EQUIPMENT REGULATIONS.
CET APPAREIL NUMERIQU� DE LA CLASSE
B RESPECTE TOUTES LES EXIGENCES DU REGLEMENT SUR LE MATERIEL BROUILLEUR DU CANADA.
CE Declaration
of Conformity
EN 55022 Compliance
(Czech Republic Only)
VCCI Notice (Japan
Only)
This is a Class B product based on
the standard of the Voluntary Control Council for Interference (VCCI) for Information
technology equipment. If this equipment is used near a radio or television receiver
in a domestic environment, it may cause radio Interference. Install and use
the equipment according to the instruction manual.
Class B ITE 
MOC Notice (South
Korea Only)
Class B Device
Please note that this device has
been approved for non-business purposes and may be used in any environment,
including residential areas.
Polish Center
for Testing and Certification Notice
The equipment should draw power from
a socket with an attached protection circuit (a three-prong socket). All equipment
that works together (computer, monitor, printer, and so on) should have the
same power supply source.
The phasing conductor of the room's
electrical installation should have a reserve short-circuit protection device
in the form of a fuse with a nominal value no larger than 16 amperes (A).
To completely switch off the equipment,
the power supply cable must be removed from the power supply socket, which should
be located near the equipment and easily accessible.
A protection mark "B" confirms
that the equipment is in compliance with the protection usage requirements of
standards PN-93/T-42107 and PN-89/E-06251.
NOM Information
(Mexico Only)
The following information is provided
on the device(s) described in this document in compliance with the requirements
of the official Mexican standards (NOM)
Exporter:
Dell Computer Corporation
One Dell Way
Round Rock, Texas 78682 U.S.A.
Importer:
Dell Computer de Mexico,
S.A.de C.V. Rio Lerma No. 302 - 4°Piso
Col. Cuauhtemoc 16500 Mexico, D.F.
Ship to:
Dell Computer de Mexico,
S.A.de C.V. al Cuidado deKuehne &
Nagel
de Mexicos. de R.I., Avenida Soles
No. 55.
Col. Penon de los Banos, 15520 Mexico,
D.F.
Supply voltage: 100-120/200-240
VAC
Frequency: 50/60 Hz
Current consumption: 1.4 A
Informacion para NOM (unicamente
para Mexico)
La informacion siguiente se proporciona
en el dispositivo o en Los dispositivos descritos en este documento, en cumplimiento
con Los requisitos de la Norma Oficial Mexicana (NOM):
Exportador:
Dell Computer Corporation
One Dell Way
Round Rock, TX 78682 U.S.A.
Importador:
Dell Computer de Mexico,
S.A. De C.V., Rio Lerma No. 302 -
4°Piso
Col. Cuauhtemoc
16500 Mexico, D.F.
Embarcar a:
Dell Computer de Mexico
S.A.de C.V. al Cuidado deKuehne &
Nagel
de Mexicos. De RI, Avenida Soles
No. 55.
Col. Penon de Los Banos, 15520 Mexico,
D.F.
Tension alimentacion: 100-120/200-240
VAC
Frecuencia: 50/60 Hz
Consumo de corriente: 1.4
A
BCIQ Notice (Taiwan
Only)
Ergonomics Notice
(Germany Only)
Under the requirements of German
ergonomics standard ZH1/618, graphics or characters.
1. Blue graphics or characters in
dark background are not recommended.
(This combination may increase eye
fatigue due to poor visibility caused by low contrast.)
2. Graphics controller and monitor
are recommended to be used in the following conditions:
- Vertical frequency : 70 Hz or
higher.
- Display mode : Dark characters
in bright background.
Ergonomie Hinweis (nur Deutschland)
Um den Anforderungen der deutschen
Ergonomie-Norm ZH1/818 zu antsprechen.
1. wird empfahlen, die Grundfarbe
Blau nicht auf dunklem Hintergrund zu verwenden (schiechte Erkennbarkelt. Augenbelastung
bei zu geringem Zeicheenkontrast).
2. wird folgende Einstellung des
Grafik-Controllers und Monitors empfohlen.
- Vertlkalfrequenz : 70 Hz oder
hoher.
- Ohne Zellensprung.
Dell Computer
Corporation's Environmental Program
Design for
Recyclability
Your Dell equipment complies with
the following principles of recyclable design:
- Avoidance of nonseparable
connections, such as gluing and welding, between different materials
- Avoidance of coatings and
composite structure materials
- Use of as few different materials
as possible
- Designed for ease of disassembly:
- Subassemblies, cables,
and components are easily detachable by one person working alone
- Minimal use of screws
- Most disassembly can
be done by hand or with the aid of a standard 6-millimeter (1/4-inch)
nut driver only
Dell�s Blue
Angel Disposal Program
Rapid technological advances lead
to a high turnover in computer products, as customers upgrade or replace their
systems at an ever-increasing rate. To address the mounting problem regarding
the indiscriminate disposal of unwanted products, and in anticipation of future
legislation, Dell has instituted a disposal program, called Green Away, for
the collection and disposal of these products.
Dell�s Green Away Program
Dell�s Green Away program is a free
material return and disposal service for Dell customers, covering computer products
sold by Dell under the environmental label plans. The returned products are
reused, recycled, or disposed of as appropriate, in accordance with local environmental
guidelines.
NOTE: The Green Away program is
designed to dispose of unwanted or unusable products under the environmental
label plans. For returned material discounts on recent purchases, or for recycling
of equipment neither sold by Dell nor covered by the environmental label plans,
contact your local Dell Asset Management specialist.
In carrying out this program, Dell�s
general responsibilities include the following:
- Organizing the reuse/recycling/disposal
of the equipment
- Ensuring that all disposal/recycling
practices meet local environmental regulations
- Monitoring the process to
ensure compliance and facilitate process improvement
How the Green Away Program Works
When you have one or more items of
equipment that you would like to dispose of, contact your local Dell customer
service department to request instructions. The returns coordinator processes
the request and advises you on the return of your material. Refer to "Green
Away Collection Sites" found later in this document for the telephone number
and collection point in your area.
NOTE: "Shells" (equipment
from which integral components, such as chips and power supplies, have been
removed) are not accepted as part of this free program. If a shell is discovered
in your shipment, you will be asked to either collect the system or pay for
its disposal.
The equipment is transported to Dell�s
Green Away partner, where it is assessed and disposed of as follows:
- If judged resellable, the
Dell label is removed and the equipment is tested, repaired, and resold.
- If judged beyond repair, the
equipment is dismantled, and usable parts are offered for sale.
Unusable parts are disposed of as
follows:
- Metal cases are sold to metals
recyclers.
- Printed circuit boards and
cases are sent to refiners.
- Plastic parts are sent to
plastic recyclers.
- Unusable packaging is sent
to paper recyclers.
Monitors are sent to recycling companies
to be disposed of as follows:
- The tubes are washed and the
luminescent powder is recovered, some elements are extracted for reuse,
and the remainder is disposed of via controlled incineration.
- Glass is sorted and sent to
the lead smelter or recycled for glass works.
- The planar mask and the iron
are sent for reuse to metals recyclers.
- Items that are not reusable
are mainly incinerated. However, if certain residues on the items are
not allowed in hazardous waste incinerators, the Dell Green Away partner
transports the items to a secured (bundled) hazardous waste landfill.
Spare Parts Policy
Dell commits to retaining stocks
of spare parts (or reasonable alternatives) for a period of five years from
the termination of production of the Dell system component�for example, the
base system, the keyboard, or the monitor.
Use of chlorine-free paper (Europe
Only)
As part of Dell�s policy to reduce
the impact on the environment of obsolete item disposal and in compliance with
guidelines in many geographical locations, all Dell documentation supplied with
Dell equipment is printed on paper (fresh fiber from sustainable resources or
recycled waste paper) bleached without the use of chlorine.
Green Away Collection
Points
Table 1 lists the country-specific
customer service telephone number along with the address for the Green Away
collection site. For Germany, the Green Away collection site telephone number
is listed rather than the customer service number.
NOTE: Locations marked with an asterisk
(*) are facilities approved for battery disposal. As Dell expands the network
of Green Away centers, additional addresses will be available across Europe.
Contact your local Dell customer service department for information about the
availability of Green Away services in your location.
| Green
Away |
Collection
Points |
|
Country
|
Telephone
|
Address
|
| Belgium |
02 481 91 00 |
R Frazier Ltd.
Plantijnweg 15,
4104 BC Culemborg, the Netherlands
|
| Denmark |
+46-8-5900 5151 |
WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
|
| Finland |
+46-8-5900 5181 |
WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
|
| Germany: |
| Northern Germany* |
0130-86-12 51 |
Bockmann/Ohlig
Tersteegenstrasse 21a
42653 Solingen
|
| Southern Germany* |
0130-86-12 51 |
Knab
Carl Benz Strasse 8-10
35440 Linden
|
| Netherlands |
02 481 91 00 |
R Frazier Europe
Plantijnweg 15
4104 BC Culemborg, Netherlands
|
| Norway |
+46-8-5900 5179 |
WMI Sellbergs AB
Box 1294
S-171 25 Solna, Sweden
|
| Sweden |
+46-8-5900 5169 |
WMI Sellbergs
AB
Box 1294
S-171 25 Solna, Sweden
|
| United Kingdom |
0800 783-3124 |
R Frazier Ltd.
Irongray Business Park
Lochside Industrial Estate
Dumfries
DG2 0NR
|
Back to Contents
Page
