CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
To connect your monitor to the computer perform the following
steps/instructions:
Turn off your computer and disconnect the power cable.
Connect either the white (digital
DVI-D) display
connector cable, the blue (analog VGA) display
connector cable, or the black DisplayPort cable to the corresponding video port on the back of your
computer. Do not use all the
cables on the same computer.
Use all the cables only when they are connected to
different
computers with appropriate video systems.
Connecting the White DVI Cable
NOTE:
Your monitor
supports two DVI ports. You can either choose DVI-D 1 or DVI-D 2 via source select button.
Connecting the Blue VGA Cable
Connecting the Black DisplayPort Cable
NOTE:
The graphics are used for the
purpose of illustration only. Appearance of the the computer may vary.
After you have completed connecting the
DVI/VGA/DisplayPort cable, follow the procedure
below to complete setting up your
monitor:
Plug the power cables for your computer and monitor into a nearby
outlet.
Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
display an image, see
Solving
Problems.
Use the cable management
slot on the monitor stand to organize the cables.
After attaching all necessary cables to your monitor and computer,
(See Connecting Your Monitor for cable attachment,)
use the cable management slot to neatly organize all cables as shown above.
