The
following table lists the physical characteristics:
Signal cable type
D-sub:
Detachable, Analog, 15pin, shipped attached to the monitor
DVI-D: Detachable, Digital, 24pin, shipped detached from the
monitor S-video: Not included with display
Composite: Not included with display
If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can
automatically reduce its power consumption when not in use. This is referred to as 'Power Save Mode'*. If
activity from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically "wake up".
The following table shows the power consumption and signaling of this automatic power saving feature:
VESA Modes
Horizontal Sync
Vertical Sync
Video
Power Indicator
Power Consumption
Normal operation
Active
Active
Active
Green
110W (maximum)*
57W (normal)**
Active-off mode
Inactive
Inactive
Blanked
Amber
Less than 2 W
Switch off
-
-
-
Off
Less than 1 W (at 230 V)
* With Audio + USB ** Without Audio + USB
This monitor is ENERGY STAR®-compliant as well
as TCO '99/ TCO '03 power management compatible.
* Zero power consumption
in OFF mode can only be achieved by disconnecting the main cable from the
monitor.
This monitor supports High-Speed Certified USB 2.0 interface.
Transfer speed
Data Rate
Power Consumption
High speed
480 Mbps
2.5W (Max., each port)
Full speed
12 Mbps
2.5W (Max., each port)
Low speed
1.5 Mbps
2.5W (Max., each port)
USB Upstream Connector
Pin Number
4-pin Side of the connector
1
DMU
2
VCC
3
DPU
4
GND
USB Downstream Connector
Pin Number
4-Pin Side of the Signal Cable
1
VCC
2
DMD
3
DPD
4
GND
USB Ports
1 upstream - rear
4 downstream - 2 on rear; 2 on left side
NOTE: USB 2.0 capability requires 2.0
capable
computer
NOTE: The
monitor's USB interface works only when the monitor is on or in power save mode,
If you switch the monitor off and then on, attached peripherals may take a few seconds to resume normal functionality.
You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display Identification Data
(EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. If desired,
the user can select different settings, but in most cases monitor installation is automatic.
CAUTION: Read and follow the
safety
instructions before cleaning the monitor.
CAUTION: Before cleaning the monitor, unplug the monitor
power cable
from the electrical outlet.
To clean your antistatic screen, lightly dampen a soft, clean cloth with
water. If possible, use a special screen-cleaning tissue or solution
suitable for the antistatic coating. Do not use benzene, thinner, ammonia, abrasive cleaners, or compressed
air.
Use a lightly-dampened, warm cloth to clean the plastics. Avoid using detergent of any
kind as some detergents leave a milky film on the plastics.
If you notice a white powder when you unpack your monitor, wipe it off
with a cloth. This white powder occurs during the shipping of the monitor.
Handle your monitor with care as darker-colored plastics may scratch and
show white scuff marks more than
lighter-colored monitor.
To help maintain the best image quality on your monitor, use a
dynamically changing screen saver and power off your monitor when not in
use.
