Manuals

Specifications: Dell 2000FP Color Monitor User's Guide

Specifications: Dell™ 2000FP Color Display User's Guide

General • Flat Panel • Resolution • Preset Display Modes • Electrical • Physical Characteristics • Environmental • Power Management Modes • Pin Assignments • Plug and Play Capability

Flat Panel

Screen type

Active matrix - TFT LCD

Screen dimensions

Diagonal 20.1 inches (510.0 mm)

Horizontal16.1 inches (408.0 mm)

Vertical 12.1 inches (306.0 mm)

Pixel pitch

0.255 mm

Viewing angle

+/- 80° (vertical) typical, +/- 80° (horizontal) typical

Luminance output

240 CD/m² typical, 200 CD/m² minimum

Contrast ratio

350 to 1 typical, 250 to 1 minimum

LCD surface coating

Hardness 3H, antiglare treatment

Backlight

6 CCFL type

Resolution

Horizontal scan range

31 kHz to 80 kHz (automatic)

Vertical scan range

56 Hz to 76 Hz (automatic)

Optimal preset resolution

1600 x 1200 at 60 Hz

Highest preset resolution

1600 x 1200 at 60 Hz

Dell guarantees image size and centering for all preset modes listed in the following table.

Preset Display Modes

Display Mode	Horizontal Frequency (kHz)	Vertical Frequency (Hz)	Pixel Clock (MHz)	Sync Polarity (Horizontal / Vertical)
IBM^®, VGA1, 720 x 400	31.5	70.1	28.3	-/+
IBM, VGA3, 640 x 480	31.5	59.9	25.2	-/-
VESA^®, 640 x 480	37.5	75.0	31.5	-/-
VESA, 800 x 600	37.9	60.3	40.0	+/+
VESA, 800 x 600	46.9	75.0	49.5	+/+
VESA, 1024 x 768	48.4	60.0	65.0	-/-
VESA, 1024 x 768	60.0	75.0	78.8	+/+
VESA, 1280 x 1024	64.0	60.0	108.0	+/+
VESA, 1280 x 1024	80.0	75.0	135.0	+/+
VESA, 1600 x 1200	75.0	60.0	162.0	+/+

Electrical

Video input signals

Analog RGB, 0.7 Volts +/-5%, 75 ohm input impedance

Digital DVI-D TMDS, 600mV for each differential line, 50 ohm input impedance

S-video, Y input 1 volt(p-p), C input 0.286 volt(p-p), 75 ohm input impedance

Composite, 1 volt(p-p), 75 ohm input impedance

Synchronization input signals

separate horizontal and vertical;
3.3V Cmos or 5V TTL level, positive or negative sync.

AC input voltage / frequency / current

90 ~264 VAC/ 47 ~ 63 Hz
1.5A (RMS) max

Inrush current at 120 V

60 A max

Inrush current at 240 V

120 A max

Physical Characteristics

Connector type

15-pin D-subminiature; DVI-D; S-video; Composite

Signal cable type

attached to display

Dimensions:(with stand)

Height

20.00inches (508mm )

Width

20.16inches (512mm )

Depth

8.94inches (227mm )

Weight (display only)

25.3 lb (11.5 kg )

Weight (with packaging)

33.2 lb (15.1 kg )

Environmental

Temperature:

Operating

41° to 95°F (5° to 35 °C )

Nonoperating

-4° to 140°F (-20° to 60°C )

Humidity:

Operating

10% to 80% (noncondensing)

Nonoperating

5% to 95% (noncondensing)

Altitude:

Operating

3,048 m (10,000 ft)

Nonoperating

12,192 m (40,000 ft)

Thermal dissipation

213 BTU/hour (maximum)
205 BTU/hour (typical)

If you have VESA's DPMS compliant display card or software installed in your PC, the display can automatically reduce its power consumption when not in use. If input from keyboard, mouse or other input devices is detected, the display will automatically "wake up". The following table shows the power consumption and signaling of this automatic power saving feature:

Power Management Definition
VESA's Mode	Video	H-sync	V-sync	Power Used	Power Saving	LED color
ON	Active	Yes	Yes	maximum 60W typical 50W	0%	Green
Stand-by	Blanked	No	Yes	<=5W	>80%	Amber
Suspend	Blanked	Yes	No	<=5W	>80%	Amber
Active-OFF*	Blanked	No	No	<=5W	>80%	Amber

This display is ENERGY STAR®-compliant .

* Zero power consumption in OFF mode can only be achieved by disconnecting the mains cable from the display.

ENERGY STAR® is a U.S. registered mark. As an ENERGY STAR® Partner, DELL has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

Pin Assignments

15-pin D-sub connector

15pin.gif (2700 bytes)

Pin Number	15-Pin Side of the Signal Cable
1	Video-Red
2	Video-Green
3	Video-Blue
4	GND
5	Self-test
6	GND-R
7	GND-G
8	GND-B
9	PC5V
10	GND-sync
11	GND
12	DDC data
13	H-sync
14	V-sync
15	DDC clock

24 pin DVI-D connector

Pin Number	24-Pin Side of the Signal Cable
1	TMDS RX2-
2	TMDS RX2+
3	TMDS Ground
4	Floating
5	Floating
6	DDC Clock
7	DDC Data
8	Floating
9	TMDS RX1-
10	TMDS RX1+
11	TMDS Ground
12	Floating
13	Floating
14	+5V Power
15	Ground
16	Hot Plug Detect
17	TMDS RX0-
18	TMDS RX0+
19	TMDS Ground
20	Floating
21	Floating
22	TMDS Ground
23	TMDS Clock+
24	TMDS Clock-

S-video connector

Pin Number	5-Pin Side of the Signal Cable
1	GND
2	GND
3	LUMA
4	CHROMA
5	GND

Composite Connector

Pin Number	1-Pin Side of the Signal Cable
1	LUMA COMPOSITE CHROMA

Plug and Play Capability

You can install the display in any Plug and Play-compatible system. The display automatically provides the computer system with its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the display settings. If desired, the user can select different settings, but in most cases display installation is automatic.

Back to Contents Page