Back to Contents Page

Using Your Adjustable Monitor Stand

Dell™ 1704FPV UltraSharp Flat Panel Monitor

  Attaching the Stand

  Organizing Your Cables

  Using the Tilt, Swivel, and Vertical Extension 

  Removing the Stand 

Attaching the Stand

NOTE: The stand is detached and extended when the monitor is shipped from the factory.

  1. Fit the groove on the of the monitor onto the three teeth on stand.
  2. Lower the monitor until it locks in to place on the stand.

Organizing Your Cables

After attaching all necessary cables to your monitor and computer, (See Connecting Your Monitor for cable attachment,) use the cable holder to neatly organize all cables as shown above.

Using the Tilt, Swivel, and Vertical Extension

Adjusting Your Monitor Using Tilt, Swivel, and Vertical Extension. You can adjust your monitor to best fit your viewing needs.


You can adjust the stand vertically, up to 5.12 inches (130mm) using the stand lock/release button. Press the stand lock/release button on the back of the monitor and then lift or lower the stand to the desired position.

NOTE: Before you move the monitor to a new location, lock the stand by lowering monitor until in clicks in to place.

Removing the Stand

 

NOTICE: After placing  the monitor panel on soft cloth or cushion, complete the following steps to remove the stand.
  1. Rotate the stand to allow access to the stand removal button.
  2. Press and hold the stand removal button while lifting the monitor up and away from the stand.

Back to Contents Page