The
proper operation of the function requires a computer with VESA™ DPMS power
management capabilities. When used with a computer equipped with VESA™
DPMS, the monitor is ENERGY STAR™
compliant. As an ENERGY STAR™ Partner, Dell
Computer
Corporation has determined that this product meets the ENERGY STAR™
guidelines for energy efficiency.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received including
interference that may cause undesired operation.
Instructions to Users: This equipment complies with the
requirements of FCC (Federal Communication Commission) equipment provided that following
conditions are met.
Power cable: Shielded power cable should be used.
Video inputs: The input signal amplitude must not exceed the
specified level.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
We hereby declare, that all major safety requirements, concerning to CE-Mark Directive
(93/68/EEC) and Low Voltage Directive (73/23/EEC), Electromagnetic Compatibility
Directives (89/336/EEC, 92/31/EEC) are fulfilled, as laid out in the guidelines set down
by the member states of the EEC Commission.This declaration is valid for all
samples that are part of this declaration, which are manufactured according to the
production charts appendix.The standards relevant for the evaluation of electrical
safety & EMC requirements are as follows :
LVD : EN 60950:1997+A1+A2+A3+A4
EMC : EN 55024:1998, EN
55022:1998, EN 61000-3-2, 3:1995
1. Certificate of conformity /
Test report issued by :
LVD : NEMKO, TUV
EMC : NEMKO
2. Technical documentation kept
at :
Samsung Electronics Co., Ltd.
which will be made available
upon request. (Manufacturer)
This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus set out in the Radio Interference Regulations of
the Canadian Department of Communications.
Note that Canadian Department of Communications (DOC) regulations
provide, that changes or modifications not expressly approved by Dell Computer Corporation
could void your authority to operate this equipment.
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil
numérique de la classe B respecte toutes les exigences
du Règlement sur le matériel brouilleur du Canada.
This equipment complies with the limits for a Class B digital device
(devices used in or adjacent to a residential environment) and conforms to the standards
for information technology equipment that are set by the Voluntary Control Council for
Interference for preventing radio frequency interference in residential areas.
The equipment should draw power from a socket with an attached
protection circuit (a three-prong socket). All equipment that works together (computer,
monitor, printer, and so on) should have the same power supply source.
The phasing conductor of the room's electrical installation should
have a reserve short-circuit protection device in the form of a fuse with a nominal value
no larger than 16 amperes (A).
To completely switch off the equipment, the power supply cable must
be removed from the power supply socket, which should be located near the equipment and
easily accessible.
A protection mark "B" confirms that the equipment is in
compliance with the protection usage requirements of standards PN-93/T-42107 and
PN-89/E-06251.
The following information is provided on the device(s) described in
this document in compliance with the requirements of the official Mexican standards (NOM):
Exporter:
Dell Computer Corporation
One Dell Way
Round Rock, TX 78682
Importer:
Dell
Computer de México,
S.A. de
C.V. Rio Lerma No. 302 - 4º Piso
Col. Cuauhtemoc 16500 México, D.F.
Ship to:
Dell
Computer de México,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de México S. de R.I., Avenida Soles No. 55
Col. Peñon de los Baños, 15520 México, D.F.
Supply voltage:
> 100/240 VAC
Frequency:
50/60 Hz
Current consumption:
1.2 A
Información para NOM (únicamente para México)
La
información siguiente se proporciona en el dispositivo o en los
dispositivos descritos en este documento, en cumplimiento con los requisitos de la Norma
Oficial Mexicana (NOM):
Exporter:
Dell Computer Corporation One Dell Way Round Rock, TX 78682
Importador:
Dell Computer de México,
S.A. de
C.V. Rio Lerma No. 302 - 4º Piso
Col. Cuauhtemoc 16500 México, D.F.
Embarcar a:
Dell Computer de México,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de
México S. de R.I., Avenida Soles No. 55
Col.
Peñon de los Baños, 15520 México, D.F.
Under the requirements of German ergonomics standard EK 1/59-98, EK
1/60-98, graphics or characters:
Blue graphics or characters in dark background are not recommended.
(This combination may increase eye fatigue due to poor visibility caused by low contrast.)
Graphics controller and monitor are recommended to be used in the
following conditions:
Vertical frequency : 60 Hz or higher.
Display mode : Dark characters in bright background.
Ergonomie Hinweis (nur Deutschland)
Um den Anforderungen der deutschen Ergonomie-Norm EK
1/59-98, EK 1/60-98 zu antsprechen.
Wird empfahlen, die Grunfarbe Blau nicht auf dunklem Hintergrund zu
verwenden (schiechte Erkennbarkeit. Augenbelastung bei zu geringem Zeicheenkontrast).
Wird folgende Einstellung des Grafik-Controllers und Monitors
empfohlen.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
In-Seop Lee / Manager 
