Jumpers/Controls/Connectors and Sockets: Dell Dimension XPS P133s, P166s, and P200s
Jumpers/Controls/Connectors and Sockets: Dell Dimension
XPS P133s, P166s, and P200s
Jumpers | Controls
| Connectors and Sockets
Jumpers
System Board Layout
 = pins 1-2 jumpered
 = pins 2-3 jumpered
Red dot denotes pin 1.
| Jumper |
|
Description |
| C, D (CPU SPEED) |
 
|
Microprocessor's internal speed is 133
MHz. |
| |
 
|
Microprocessor's internal speed is 166
MHz. |
| |
 
|
Microprocessor's internal speed is 200
MHz. |
| A, pins 1-3 (PASSWORD) |
 (default)
|
Password features are enabled.
Password features are cleared at next system boot.
|
| A, pins 4-6 (CLEAR CMOS) |
 (default)
|
System setup settings are retained at
next system boot.
System setup settings are cleared at next system boot
 |
NOTE: If the system setup
settings become corrupted to the point where the
system will not boot, put the jumper across pins
5 and 6, and turn on the system. Then turn off
the system, replace the jumper across pins 4 and
5, and rerun the system setup program. |
|
| B, pins 1-3 (SETUP ACCESS) |
 (default) 
|
Allows user to enter system setup
program.
Prevents user from entering system setup program.
|
| B, pins 4-6 (RESERVED) |
 (default) |
Reserved. Do not change. |
| J6M1, pins 2-3 (RESERVED) |
 (default) |
VRE jumper. Reserved. Do not change. |
Front-Panel Controls/Indicators
Desktop System
Mini Tower System
| Control/Indicator |
Description |
| Power Button |
The power switch is a push-button
switch. |
| Power Indicator |
The power indicator lights up when the
system is on. |
| Reset Button |
Pressing the reset button initiates a
hardware reset. To avoid possible data or file structure
corruption, use the reset button only when the system
cannot be rebooted with the
<Ctrl><Alt><Del> key combination, and
then perform an orderly shutdown of the operating system. |
| Hard-Disk Drive Access Indicator |
The hard-disk drive access indicator
lights up when the hard-disk drive is being accessed. |
| Diskette-Drive Access Indicator |
The diskette-drive access indicator
lights up when the diskette drive is being accessed. |
Connectors and
Sockets
| Connector or Socket |
Description |
| 3.3V |
3.3-V power input connector |
| BANK0, BANK1 |
DIMM sockets |
| BH9L1 |
Battery socket |
| COAST |
Cache card socket |
| FLOPPY |
Diskette-drive interface connector |
| J1A1, J1A2, J1B1 |
ISA expansion-card connectors |
| J2C1, J2D1, J2E1, J2E2PCI |
Expansion-card connectors |
| J2F2 |
CD-ROM drive audio cable connector |
| J7M1 |
Microprocessor fan connector |
| J9E1 |
Control panel connector |
| POWER |
Power input connector |
| PRI IDE |
Primary EIDE channel connector |
| SEC IDE |
Secondary EIDE channel connector |
| U3L1 |
Microprocessor socket |
| WAVE |
Wave table expansion card connector |
|
