Specifications: Dell Dimension� XPS P90c/P100c/P120c/P133c/P150c/P166c
Specifications: Dell Dimension XPS
P90c/P100c/P120c/P133c/P150c/P166c
Microprocessor | System Information | Expansion Bus | Memory
| Drives | Ports |
Video | Processing-Speed Key
Combinations | System-Function
Key Combinations | Power | Physical | Environmental
| Regulatory Notices
| Microprocessor
type |
3.3-V P54C Intel�
Pentium� chip |
| Microprocessor
speeds |
90/60 MHz
100/66 MHz
120/60 MHz
133/66 MHz
150/60 MHz
166/66 MHz |
| Internal
cache |
8-KB instruction
8-KB data |
| Math
coprocessor |
internal |
| Microprocessor
socket |
ZIF |
| System chip set |
Intel 82430FX PCIset |
| Data bus
width |
64
bits |
| Address bus
width |
32
bits |
| DMA channels |
7 |
| Timers |
3 |
| Interrupt map |
15 |
| Flash BIOS
EPROM |
128 KB |
| Serial port
UART |
16550-compatible |
Buffer
|
16
bytes |
| Bus
type |
ISA and PCI |
| ISA
expansion slots |
4 (1 connector shares a
card-slot opening with a PCI connector) |
| PCI
expansion slots |
4 (1 connector shares a
card-slot opening with an ISA connector) |
| ISA
bus speed |
7.5 MHz with 120-MHz CPU
8.33 MHz with 100-MHz CPU |
| PCI
bus speed |
30 MHz with 120-MHz CPU
33 MHz with 100-MHz CPU |
| PCI
data transfer rate |
100 MB/sec |
| Architecture |
fast-page mode or EDO |
| Wait states |
near zero |
| SIMM sockets |
4 |
| SIMM
capacities |
4, 8, 16, and 32 MB |
| SIMM type |
32-bit, nonparity |
| Minimum RAM |
8 MB |
| Maximum RAM |
128 MB |
| Memory access time |
|
tRAC
|
60-ns EDO
or 70-ns fast-page mode |
tCAC
|
20 ns |
| External cache |
256-KB asynchronous
256-KB pipeline burst
512-KB pipeline burst module * |
| Speed |
15 ns |
| Type |
nonremovable from
daughter board |
| BIOS address |
E0000 - FFFFFh |
* The 512-KB cache is standard on the P133c and optional on the P120c. It is not currently available on the P90c and P100c.
| Externally accessible
bays |
(3) 5.25-inch bays
(1) 3.5-inch bay |
Internally accessible bays
|
(2) 1-inch bays |
| Externally accessible: |
|
| Serial
(1 & 2) |
(2) 9-pin connectors
(16550-compatible) |
| Parallel |
(1) 25-hole connector
(bidirectional) (AT-, PS/2-, ECP-compatible) |
| Video |
(1) video card |
| PS/2-style keyboard |
(1) 6-pin mini-DIN |
| PS/2-compatible mouse |
(1) 6-pin mini-DIN |
| |
|
| Internally accessible: |
|
| Primary
EIDE |
40-pin connector
(hard-disk drives only) |
| Secondary
EIDE |
40-pin connector
(non-hard-disk EIDE devices) |
| Diskette
drive |
34-pin connector |
No on-board video in this system.
<Ctrl><Alt><\> toggles microprocessor
speeds on 101-key keyboard.
<Ctrl><Alt><#> toggles
microprocessor speeds on 102-key keyboard.
<Ctrl><Alt><Del> restarts (reboots) the computer
 |
NOTE: There are no
hot-key combinations for entering the system setup
program. Press <DEL>
when prompted. |
| DC power supply: |
|
| Wattage |
230 W |
| Voltage |
90 to 135 V at 60 Hz or
180 to 265 V at 50 Hz |
| Height |
40.64 cm (16 inches) |
| Width |
20.32 cm (8 inches) |
| Depth |
40.64 cm (16 inches) |
| Weight |
11.3 to 13.6 kg (25 to 30 lb) |
| Temperature: |
|
Operating
|
10 to 35C
(50 to 95F) |
Storage
|
-40� to
65�C (-40� to 149�F) |
Relative humidity
|
8% to 80%
(noncondensing) |
| |
|
| Vibration: |
|
Operating
|
0.25 G at 3
to 300 Hz for 15 minutes |
Storage
|
0.5 G at 3
to 300 Hz for 15 minutes |
| |
|
| Shock: |
|
Operating
|
5 G for 11
ms |
Storage
|
20 G with a
velocity change of 1397 mm/sec |
| |
|
| Altitude: |
|
Operating
|
-16 to 3048
m (-50 to 10,000 ft) |
Storage
|
-16 to
10,600 m (-50 to 35,000 ft) |
FCC (U.S.
only)
|
Class B |
DOC
(Canada)
|
Class B |
CE
|
Class B
|
FCC ID
|
E2KP510CMT
|
| UL |
For computers set at 115 V  Use a UL-certified grounded
cable, type SVT or SJT, with a minimum of 18 American
wire gauge (AWG). The cable must be no longer than 15
feet and must have a parallel-blade, grounded plug rated
for 15 A. For computers set at 230 V (within the U.S.)
Use a UL-certified grounded
cable, type SVT or SJT, with a minimum of 18 AWG. The
cable must be no longer than 15 feet and must have a
tandem-blade, grounded plug rated for 15 A/250 V.
For computers set at 230 V (outside the U.S.) Use a grounded cable, type SVT or
SJT, with a minimum of 18 AWG. The cable must be no
longer than 15 feet, must be rated according to the
requirements of the country in which the equipment is to
be used, and must have a grounded plug. The cable should
be labeled "HAR" and should have the
appropriate safety approvals for each country.
|
|
