DTA: Jumpers/Switches/Controls
Jumpers/Switches/Controls
Jumpers
Controls
Jumpers
Jumper Locations
 = pins 2-3 jumpered
 = pins 1-2 jumpered
 = pin 1
66/60  (default) Reserved (do not change)
RCVR FLASH  (default) Reserved (do not change)
CMOS NRM/CLR  (default) System setup settings are retained when the
system boots.
 System setup settings revert to their defaults
when the system boots.
(If the system setup settings become so
corrupted that the system does not boot, put the
jumper plug on pins 2-3 and boot the system.
Reset the jumper plug on pins 1-2 before
restoring the system setup settings.)
SETUP  (default) Allows the user to enter the system setup
program.
 Prevents the user from entering the system
setup program.
FLASH WP  (default) Reserved (do not change)
MONO/CLR  (default) Color monitor
 Monochrome monitor
ENA/DIS PSWD  (default) The password feature is enabled.
 The password feature is disabled.
Controls
All controls are located on the front panel
Reset control push button
Power control push button
Power indicator green LED
Hard-disk drive access indicator green LED
| 
