Manuals

Memory: Dell Dimension XPS 4100V & XPs 466V

Base/Board Memory | Installing/Removing Memory | Memory Map

Base/Board Memory

Installing/Removing Memory

Memory Installation Guidelines:

• The 4 SIMM sockets can accommodate from 8 to 64 MB of RAM.
• Supported SIMM sizes are 4 and 16 MB, rated at 70 ns or better.
• SIMMs are 32-bit (72-pin) nonparity.
• Install the smaller SIMMs in the first sockets, beginning with bank 0.
• Do not leave any blank sockets between SIMMs.

Location of SIMMs
Removing and Replacing SIMMs

Removing a SIMM

Spread the inner metal tabs of the SIMM socket apart just far enough for the SIMM to disengage from the socket (it should pop out slightly). Then lift the SIMM away from the socket.

Installing a SIMM

When replacing existing SIMMs, temporarily remove any SIMMs installed in front of those being replaced.

1. Hold the SIMM at a 45-degree angle with the cutout facing the back of the chassis.
   Align the SIMM's edge connector with the center of the SIMM socket.
2. Insert the SIMM's edge connector firmly into the SIMM socket.
3. Rotate SIMM to the left until it clicks into place.
   The metal tabs at each end of the socket snap into place around the SIMM, and the retention pegs snap into the holes at the end of each SIMM.
4. If the system memory capacity changed as a result of replacing SIMMs, enter the System Setup program and verify that the Extended Memory category displays the correct amount of installed memory.
5. Reboot the system from a diagnostics diskette, and run the RAM Test Group to test all SIMMs.

Memory Map