|
Requirements to Run the DACCF Utility
Requirements to Run the DAC Utility
 MS-DOS 5.0 or later
A system with a DAC960PL disk array controller installed in it
All of the disk drives properly connected to the DAC960PL and powered on
One diskette disk drive
NOTE: The DAC utility is always run from a diskette drive.
Once the user has completed the configuration, the resulting data is written to the controller's nonvolatile memory and flash EEPROM. The next time the system is rebooted, the controller uses this information to organize the storage system's presentation to the operating system.
| 
