DTA: SmartVu� Error Codes
SmartVu� Error Codes
Error Code Description
1> 232 RS-232 base setup
2> 8042 Keyboard controller test failed
3> 8042 controller error-304 Keyboard controller test failed
4> 8087 Check for 80287 IC present
5> 8254 timer failed-104 8245 IC failed self-test
6> 8259 #1 Stray interrupt-101 Master interrupt controller failed
7> 8259 #2 failed-102 Slave interrupt controller failed
8> AA55 PG?? Port pattern test failed ??=Port #
9> AD10-1F Addresses shorted test (A0-A15)
10> AD20 Gate A20 inoperational
11> Boot Shutdown for bootstrap
12> bmov Block move of data to/from virtual memory
13> CK00 Processor flags test
14> CK01 Read shutdown code, determine whether system reset or
processor shutdown
15> CK02 Initialize data & stack segments
16> CK09 ROM checksum failed
17> CK60-63 Diskette unit initialization
18> CK64 Hard-disk unit initialization
19> CKCS ROM checksum failed
20> CKH1 Processor register pattern test
21> CmEr CMOS IC not working
22> CMOS CMOS battery and checksum test
23> CMOS Battery-161 Battery backup failure
24> CMOS checksum-163 ROM checksum failed
25> CMOS display mismatch-401 Display adapter in system does not match CMOS setup
26> CMOS floppy drive-type One or more diskette drives do not match the CMOS setup
mismatch-603
27> CMOS memory mismatch-164 Total memory in system does not match total memory from
last setup
28> CMOS time not set-163 Invalid time in CMOS setup
29> CO80 6845-color mode test
30> Csr0 Cursor read/write test on color card
31> Csr1 Cursor read/write test on mono card
32> Diskette boot failure Read error with system files on diskette drive
33> Diskette drive not ready diskette drive not ready error
34> Display switch incorrect-501 Switch #1 on 286 motherboard does not match display adapter
in system
35> DM11 Disable DMA & interrupt controllers
36> DMA1 DMA master controller failed
37> DMA2 DMA slave controller failed
38> DmEn Initilalize 8237 DMA controllers
39> DmFF DMA controller F/F latch test
40> ER02 rplc PL CPU internal computation failure
41> ER03 rst chips, rplc PL Multiple RAM errors in low 64 KB
42> ER04 chk vid SWT; rst,rplc VC Video display adapter memory error
43> ER05 rst, rplc BIOS ROM checksum error
44> ER06 rst parity chip, rplc PL Parity error status bit can't be reset
45> ER07 rplc CMOS, rplc Pl 8245 Timer is inaccurate or not clocking
46> ER08 rplc Pl Programmable logic array or RAM refresh failure
47> ER09 rplc Pl 8742 controller A20 Gate not operating well in Virtual mode
48> ER10 reset SWT or send in Pl Virtual mode exception error or memory failure
49> ER11 rst cards/SWT, rplc Pl 14-MHz crystal shorted or inoperational
50> Error 8042 Gate A20 Gate A20 inoperational
51> Error 8259 #1-101 Master interrupt controller failed self-test
52> Error 8259 #2-102 Slave interrupt controller failed self-test
53> Error on DMA 1 Master DMA channel registers failed port pattern test
54> Error on DMA 2 Slave DMA channel registers failed
55> Error on DMA page DMA page registers failed port pattern test
56> FAST CPU not operating at high clock rate, oscillator failure?
57> Fixed disk boot failure Read error with system files on hard drive
58> Fixed disk controller Controller failed POST
failed-1782
59> Fixed disk partition invalid No system files found or accessible
60> Fixed disk error 1790 Hard drive 0 failed verification test
61> Fixed disk error 1791 Hard drive 1 failed verification test
62> Fixed disk error 1780 Hard drive 0 not ready
63> Fixed disk error 1781 Hard drive 1 not ready
64> Floppy disk cont. failed-601 Controller failed reset command
65> HALT Processor shutdown
66> Inoperational CMOS CMOS failed self-test
67> INTO Interrupt controller self-test
68> INT1 Keyboard interrupt self-test
69> INT2 Check for keyboard interrupt
70> INT3 Test to see if keyboard interrupt received
71> INT4 Copy back to original vectors
72> Intermittent memory read After nonmaskable interrupt parity error was not found
73> INTV Initialise interrupt vectors and global segments, begin
using stack (64 KB) ok
74> Invalid boot diskette No system files found or accessable
75> Invalid opcode cs:ip Invalid data (not limited to the opcode)
76> Kb30 Reset keyboard
77> Kb31 Check for keyboard response
78> Kb32 Keyboard ECHO command test
79> Kb33 Enable keyboard
80> Kb37 Initialize keyboard circular buffer
81> Keyboard 8742 error-303 8742 failed self-test
82> Keyboard error-101 Keyboard failed self-test
83> Keyboard locked. Unlock to Keyboard is locked out
continue-302
84> Lock Keyboard is locked out
85> MATH Test 80287 IC
86> Math Coprocessor Mismatch-162 BIOS differs from CMOS on math coprocessor installation
87> Mfg-Test System is in self-test loop
88> Msiz Verify base RAM size
89> No resident BASIC System does not support BASIC (Int 18)
90> Optr System ROM test
91> Parity error in Bmem System parity error
92> Parity error in Xmem External board (I/O) parity error
93> PgEr DMA page register test failed
94> Prnt Printer base setup
95> PT19-22 Parity & refresh curcuit test
96> RAM0 Sequential data read/write test base 64 KB
97> RAM1 Clear base 64-KB memory
98> RAM2 Clear base memory
99> RAM3 Sequential pattern read/write test
100> RAM4 Random data address write
101> RAM5 Random data verify
102> RAM parity check disabled-208Parity check option disabled
103> RAM parity errors Parity errors detected by POST
detected-207
104> rMem CPU executing in Real mode
105> S123 Defective SIM module: S=SIM 1 and 2=module (1-24), 3=RAM
IC on module (1-8)
106> SD00 Shutdown code for hard reset to system
107> SD01 Shutdown code for soft reset to system
108> SD02 Virtual mode exception interrupt error
109> SD03 Shutdown after memory
110> SD04 Shutdown for boot loader
111> SD05 User define shutdown
112> SD06 Shutdown for display memory size
113> SD09 Shutdown after block move
114> SD0A User define shutdown
115> SDVX Exception interrupt shutdown
116> TM14 8254 timer test channel 2
117> TM15 8254 timer count test
118> TM16 8254 delta count test-channel 2
119> TM17 8254 delta count-test-channel 1
120> TM18 8254 delta count-test-channel 0
121> U 71 Reference designator of a failing RAM IC
122> VEGA EGA ROM found
123> vMem CPU executing in Virtual mode
124> VROM Check the integrity of video ROM
|