CAUTION |
| Use the following safety guidelines to help
protect your projector from potential damage and to ensure your own
personal safety: |
- The lamp becomes very hot with use. Do not attempt to replace
the lamp after use until the projector has been allowed to cool
down for at least 30 minutes, and follow all instructions in "Changing
the Lamp."
|
- Do not touch the bulb or the lamp glass at any time. The bulb
may explode due to improper handling, including the touching of
the bulb or the lamp glass.
|
- Remove lens cap before turning on projector. Failure to do so
may cause the lens cap to reach high temperatures.
|
- To avoid damaging the projector and lamp, allow the cooling
fan to run for 2 minutes before turning off the projector.
|
- The remote control is equipped with a Class II laser that emits
laser radiation. To reduce the risk of injury, do not look directly
into the laser light, and do not point the laser light into anyone's
eyes.
|
- Do not block the ventilation slots and openings on the projector.
|
- Disconnect the power cord from the electrical outlet if the
projector is not used for a long period of time.
|
- Do not use the projector in an extremely hot, cold, or humid
environment.
|
- Do not use the projector in areas susceptible to excessive dust
and dirt.
|
- Do not use the projector near any appliance that generates a
strong magnetic field.
|
- Do not place the projector in direct sunlight.
|
- Do not look into the lens while the projector is on; the bright
light may hurt your eyes.
|
- To reduce the risk of fire or electric shock, do not expose
the projector to rain or moisture.
|
- To prevent electric shock, do not open or disassemble the projector
further than what is needed for lamp replacement.
|
- To avoid damaging the projector, ensure that the zoom lens and
elevator foot are fully retracted before moving the projector
or placing the projector in its carrying case.
|
- Turn off the projector and disconnect it from the electrical
outlet before cleaning it. Use a soft cloth moistened with mild
detergent to clean the display housing. Do not use abrasive cleaners,
waxes, or solvents.
|