Manuals

All indicators are off	AC Cord is not connected to wall outlet	Connect AC power
asdf	Control Speaker is not connected to the subwoofer	Connect control speaker to subwoofer
asdf	Power is off	Press power button or use remote to turn on the system
No Sound from all Speakers	Power is not on	Verify the AC line cord is plugged into the wall outlet
asdf asdf	asdf	Verify power switch has been pressed (green Power LED is lit)
asdf	Volume setting is too low	Raise master volume control
sdf	S/PDIF cable is not connected to DVD playback card	Connect S/PDIF cable
sdf	Signal cable is disconnected from sound card	Connect signal cable
asdf	Right (Control) speaker is disconnected	Connect right (Control) speaker
Mute turns off unexpectedly	Mute was re-pressed or a function was selected	System will un-mute whenever the mute button is pressed again, if a function button is pressed, or if the volume control is rotated
Subwoofer emits very loud humming/buzzing noise	Signal cable is not completely inserted into signal jack on subwoofer	Make sure cable is inserted snugly into signal jack
No sound from Subwoofer	Subwoofer volume is too low	Select Bass function and raise volume level
asdf	asdf	Press and hold Treble and Bass buttons for 3 seconds to reset Treble, Bass, Center, and Surround levels to default position.
No sound from surround speakers	Unit is not in a surround mode	Press the mode button to select a surround mode. Prologic - Amber Dolby Digital - Green
	Surround level is too low	Select surround level function and raise volume
asdf	asdf	Press and hold Treble and Bass buttons for 3 seconds to reset Treble, Bass, Center, and Surround levels to default position
Center and Surround buttons do not work	Unit is not in a surround mode	Press the mode button to select a surround mode. Prologic - Amber Dolby Digital - Green
No sound from surround speakers when detached	Surround bases are not connected	Connect surround bases to rear of subwoofer
asdf	Unit is not in a surround mode	Press the mode button to select a surround mode. Prologic - Amber Dolby Digital - Green
asdf	Surround level is too low	Select surround level function and raise volume
asdf	asdf	Press and hold Treble and Bass buttons for 3 seconds to reset Treble, Bass, Center, and Surround levels to default position
No playback from digital input	Digital signal cable is not connected	Connect digital signal cable to S/PDIF output of DVD playback card
Sound is distorted	Volume level too high	Decrease master volume level
Not enough treble	Treble setting is too low	Select Treble function and increase level
asdf	asdf	Press and hold Treble and Bass buttons for 3 seconds to reset Treble, Bass, Center, and surround levels to default position
Too much treble	Treble setting is too high	Select Treble function and decrease level
asdf	asdf	Press and hold Treble and Bass buttons for 3 seconds to reset
asdf	asdf	Treble, Bass, Center, and surround levels to default position
Too much bass	Bass setting is too high	Select Bass function and decrease level Press and hold Treble and Bass buttons for 3 seconds to reset Treble, Bass, Center, and surround levels to default position
Remote Control does not work	Batteries are dead or not installed	Replace or install new batteries
asdf	Remote is not pointed at speakers	Point remote control at the left side of LED bar
asdf	Remote signal path is blocked	Remove any object that is blocking the signal from the remote to the left side of the LED bar