Manuals

Back to Contents Page

Introduction: Dell™ External USB PAL/SECAM/DVB-T TV Tuner User’s Guide

Overview

Features

I/O

Software

Platform Requirements

Getting Help

Warranty Information

Overview

The Dell External USB PAL/SECAM/DVB-T TV Tuner is an external USB 2.0 bus-powered tuner that works with Microsoft® Media Center Edition (MCE) 2005 and Windows Vista™.

Features

The Dell External USB PAL/SECAM/DVB-T TV Tuner provides the following features:

1. View or record (to disk) video from a Composite, S-Video, analog TV, or digital TV (DVB-T) source
2. View or record (to disk) analog audio. Source may be an external source (DVD or VCR player, and so on) or analog or digital TV
3. High quality video processing provides a cleaner and a low noise picture
4. Lead-free and the restriction of the use of certain hazardous substances compliant design

I/O

The USB device consists of:

• One IEC connector (connects to TV antenna or cable) [TV IN]
• One 4-pin mini-DIN (S-Video) connector [S-Video]
• One RCA-type (yellow, composite video) connector [Video]
• Two RCA-type (white and red) audio connectors [Audio Left and Audio Right]
• One USB type B connector

Front View

Rear View

Software

The Dell External USB PAL/SECAM/DVB-T TV Tuner hardware ships with the following software:

• Driver setup utility (DrvInstall.exe)
• WDM driver (WaveDVBT.sys, WaveDVBT.inf, EzRating.dll)
• Diagnostic utility (WaveDiag.exe, WaveDiag.cfg, Wave.dev)

The Dell External USB PAL/SECAM/DVB-T TV Tuner is supported by Microsoft Windows XP Media Center Edition (MCE) – 2005 and Windows Vista release.

Drivers use standard Microsoft DirectShow® property sets. The drivers can be found on the Dell Resource CD. An Install Shield is provided to make installation simple. Store the Resource CD that comes with your system in a safe place in case you need to reinstall the software.

Platform Requirements

• Microsoft Windows XP Media Center Edition 2005
• Minimum 256 MB RAM, 512 MB Recommended
• 1.8 GHz Processor, 400 MHz Front Side Bus
• DirectX® 9.1 or higher
• Minimum two available USB type A ports:

  • one for the Dell External USB PAL/SECAM/DVB-T TV Tuner (must be USB 2.0);

  • one for the Media Center remote control receiver;

• 5400 RPM or faster disk drive

Note: Disk DMA must be enabled for proper operation.

Getting Help

If you need additional help or require information that is not included in this guide, visit the Dell Support website support.dell.com or call 1-800-BUY-DELL

Warranty Information

See your Dell system warranty information for service and repair options available for your Dell External USB PAL/SECAM/DVB-T TV Tuner product.

 Back to Contents Page