Manuals

Regulatory: Promise® FloppyMAX LS-120 Controller Board User's Guide

Promise Technology, Inc., has informed Dell that it has achieved approval or certification, as appropriate, from the following organizations. Dell does not independently verify these approvals or certifications. Please direct questions regarding such approvals to Promise Technology, Inc.

FCC COMPLIANCE

Each FLOPPYMAX is equipped with an FCC compliance label and an FCC identification number. The full text of the associated label is:

RADIO FREQUENCY INTERFERENCE STATEMENT

CAUTION: Changes or modifications to the FLOPPYMAX not expressly approved by PROMISE TECHNOLOGY, INC. could void the user's authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult Promise Technology, Inc. or an experienced radio/TV technician for help

This device complies with Part 5 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: Only digital device equipment CERTIFIED CLASS B should be attached to this equipment and that must have shielded cables.

Please read all restrictions and disclaimers.

Back to Contents Page