|
Connectors and Jumpers: Promise FloppyMAX LS-120 Controller Board User's Guide
Back to Contents Page
Connectors and Jumpers: Promise® FloppyMAX LS-120
Controller Board User's Guide
Figure 1. Layout of the Promise FloppyMAX LS-120
Controller Board
Table 1. Connectors and Jumpers
| J1 |
40-pin internal IDE connector |
| J2 |
IRQ settings |
| J3 |
IDE enable/disable;
IDE tertiary/quaternary |
| J4 |
BIOS address |
| J5 |
BIOS enable/disable |
Your FloppyMAX supports tertiary (3rd) and quaternary
(4th) IDE port addresses. The default is quaternary and should not conflict
with most systems. Change to the tertiary address by moving JP3 from pins
4-5 to 5-6 (see Table 2) if the default port is used. (Your sound card may
have a tertiary port).
Table 2. Jumper Settings for the Promise FloppyMAX
LS-120 Controller Board
Please read all restrictions
and disclaimers.
Back to Contents Page
| 
