|
External Media Bay: Dell Latitude L400 User's Guide
Back to Contents Page
External Media Bay: Dell™ Latitude™ L400 User's
Guide
You can use the external media bay (see Figure 1)
for the diskette drive that comes with your system. Alternatively, you can install an
optional device (such as a CD-ROM, CD-RW, DVD-ROM,
Zip 250, or non-bootable second hard-disk drive) in the bay.
 |
NOTE: If desired, you can use
the media bay cable to connect a device directly to the external media bay connector,
without using the external media bay. |
To install a device in the external media bay, perform the following steps:
- If your computer is running the Dell-installed Microsoft®
Windows® 98, Windows NT®, or Windows Me operating
system with Softex BayManager installed: Right-click the Softex icon (the icon looks like
an open portable computer) in the Windows system tray on the taskbar. Then click either Remove
or Swap Devices or Insert Bay Devices, either of which causes
the system to enter suspend (or standby) mode.
If you have Windows NT, Windows 98, or
Windows Me and it is not running one of the Softex programs:
Save
your work, close all open files and application programs, and turn off the computer.
If you have Windows 2000: Device swapping in the media bay is
supported by the operating system. Although you can physically remove and install devices
as described in the following subsections, refer to the information on unplugging or
ejecting hardware in your Windows 2000 documentation instead of following the
Softex-related steps in this section.
NOTICE: When a device is not inside the
external media bay, it is fragile and must be handled carefully to avoid damage. Do not
press down on it or place a heavy object on top of it. Place extra devices in a
travel case to keep them free of dust and liquids. Store devices in a safe place.
- If the external media bay contains a device, remove the device as follows:
- Remove the media bay cable from the back of the bay.
- Turn the media bay over.
- Slide the release latch on the bottom of the bay toward the unlock icon.
- Hold the latch in the unlock position with one hand and pull the device out of the bay
with the other hand.
- Release the latch, and then turn the media bay back over.
- Slide the new device firmly into the external media bay.
You should hear a click when the device is fully seated.
NOTICE: To avoid overheating the computer, do not place the external media bay close
to the air inlet or fan intake/exhaust vents (see Figure 1).
- Connect the media bay cable as follows:
- Position the larger of the cable connectors with its shiny metal lip
down, and connect it firmly to the device through the slot in the back of the bay.
- Make sure that the securing clips are fully engaged and the connector
is fully seated.
- Connect the other end of the cable to the media bay connector at the
back of the computer (see Figure 1).
Figure 1.
External Media Bay
 |
| 1 |
Fan intake/exhaust vents |
| 2 |
Air inlet |
|
- If your computer is running Softex Bay Manager: Click
OK at the Softex Bay Manager screen. Click OK
at the Device Removal screen (if it appears), and then click OK
at the Device Configured screen.
If you turned off the computer in step 1: Press the power button to turn the
computer back on.
Back to Contents Page
|
